Some tools required to build your chopper

Incase you are intending to build your chopper, then it is essential that you have the right kind of specialty tools that enable you to have the work done more efficiently along with the best results. There are some of the tools that will enable you to have a better control over the chopper; this article will provide you with some of the best specialty tools that would be useful in enhancing the value of the chopper.

Chain breaker: The main link in a motorcycle chain is installed with the aim that the chopper has to be sturdy and it should not loosen at the wrong time. This indicate that incase you are intending to remove the chain it would be quite difficult to cut off the master link. For this purpose it is essential that you purchase a chain breaker it is not much expensive and worth spend as it would be useful to you every time you are intending to work on the chopper.

Chain press tool: It is quite obvious that once you remove the chain you need to install it back to the chopper. It is a handy tool that makes the task of fitting the chain back into the chopper and even avoids you from using the hammer and then again banging hammer on to your hammer and making your thumb turn blue.

Clutch Holding tool and clutch spring compression tool: These two pair of tool are handy and easily portable. There are times when you need to work on your bike alone nobody to hold the clutch, in such a time you will need to hold a clutch holding tool which can have the clutch held in compressed position. On the other hand the clutch spring compression tool is a must to have while you are working on your clutch. You can get the clutch holding compression tool at almost $100- $125.

Handle bar and sub frame straightener: In case there are vents in your chopper frame and you need to straighten in then this sub frame straightener will be of great help to you. This straightener tool is of great help as it is quite easily available almost all places at a very reasonable price. While purchasing this tool just ensure that you buy a quality product as it is essential that the tool should be able to bear a lot of pressure.

Compression tester: The rebuilding of the engine or the other trouble shooting work would become an easier task if you wok with the help of a compression tester. A good quality compression tester will not cost you anything more than hundred dollars.

Hydraulic brake bleeder: Incase you are person who likes to work alone while you are designing your best chopper then the brake bleeder will allow you to break the lines of tapped air.